Recent content by caesar

Trowbridge, Wiltshire.

Gone but not forgotten! :(

1968 RHD custom lowered Dormobile One of the straightest bays I’ve ever seen, and so much fun to drive Body work (Within the last 18 months it has had) All rust cut out and new metal fabricated to fit. New front passenger arch Complete smooth front end. Indicators relocated to front...

Hey man, lifes too short and this isn't VZI..... :wink:

Never had any problem with these on the front of my van! They shouldn't go down. Hope this helps.

Sorry to pee on your post, but i never said i comes and goes! :wink: The problem came and stayed, due to lack of fluid in the brakes. Thanks anyway.

All sorted guys. The accelerator cable had eaten its way through one of the solid brake lines coming from the master cylinder. Im pretty sure they shouldn't have been touching each other at all, but will relocate it a bit when i refit. Thanks again for all your help and advice peeps.

Hopefully nothing too expensive then! Nice of it to happen over christmas and new year! lol

Cheers for the reply's all. Its drums all round, that were all blead a few months back. It just weird how it didn't start immediately after braking hard yesterday. I will get out tomorrow and have a look, hopefully its just a flexi hose gone and the fluid level has dropped.

Hi All Bus is a 68 bay Last night on my way home from devon, i had to brake hard at some traffic lights...... Alot harder than i normally like too. Everything seemed fine after that and i got home fine, but ive just taken the van out again and it drove fine for a few miles and then at a...

Yeah thats right mate. What a joke of a thread, i dont know why people have to be like that and the message i got was hillarious. :roll: Unfortunately it was someone that i've had disagreements with before when they were being an arse hole on another subject. LOL :D :lol:

I went on VZI yesterday and commented on a thread about a guy who was posting up pics of his caddy and got slated for putting a title of the ultimate rat. It was the guys 2nd post on VZI and people were ripping him a new one. I commented, saying lay off and give the guy a break, he's new etc...

Ah, did you have any metal tube in the end to absorb the heat or was it just plastic onto the heat exchangers? Cheers

unfortunately both ends are the same size!

Cool thanks So if the heat sheild should be on there, then they definately wont go on. lol Didnt really want to start fabricating stuff up to attach the 2 pipes, would rather get the right bits on in the first place. Anbody else got any ideas or pictures of how theres go together!? Cheers