Help Support Early Bay Forum:
static
Well-known member
- Joined
- Last seen
- Messages
- 71
- Reaction score
- 98
Latest activity Postings About
-
-
static replied to the thread Wheel Arches are flat on my 1972 Crossover?.This reminds me of the era when only Late Bay front end replacement skins were available. It used to throw us off when we would attempt... -
Hello, i'm Sascha from Germany. I live near Berlin. After building my wife a pool and patio i was allowed to buy a project 😅. I bought a...
-
Did the seat covers and bunks myself. All insulated.
-
Can’t wait for a bit of warmer weather so I can finish of the heater install! And get back driving the bus 😁 So until then to keep me...
-
One cent shy of US$80 is a LOT of money for a pair of hinges, even without the added cost of shipping!
-
As above the reason it's a double thickness is to level the floor out, where the inner sills sit is higher than the load floor itself...
-
static replied to the thread More stainless clutter.Agreed. About three times too much, but they’re stainless! Whether they’re useful or practical is not my department.
-
static replied to the thread More stainless clutter.Off the shelf from an odd merchant of whom I know little about. The red type above is a hyperlink to it.
-
I found a source for stainless steel hinges that go above the engine lid. Installed them a few days ago. Their final cost gave me the...
-
-
static reacted to [email protected]'s post in the thread Stainless Steel Accelerator Return Spring with
Like.
Actually laughed out loud reading that 😂 I do too have a penchant for nice springs on throttle linkage 👌🏻😎 -
static replied to the thread Dual port Inlet manifold boots.A VW boutique that I used to frequent had problems with those boots. They tried several different pair (all that looked good) from...
-
static reacted to ozziedog's post in the thread Stainless Steel Accelerator Return Spring with Like.
I think I have just turned green with envy. In my sad existence, :rolleyes: my spring is a specifically coated one and matches the rest...
-
In my never-ending (yet pointless) quest to replace everything possible with its stainless steel equivalent, I have replaced my...
-
-
Hi All Apologies for long delay. I eventually solved the problem, via a experienced auto electrican. He ran a check on the feed to the...
-
Loading…
-
Loading…
