Recent content by Stuster

Hello! Very quick question. I have a ‘71 Cali early bay with a CA code gearbox. I have a CU code gearbox sitting in the garage- is the CU code box compatible with the early bay?

Has anyone heard of N2 Engineering? Selling refurbished early bay steering boxes on eBay with 12 month warranty.

Hi all Not been on here a while- so hope everyone is ok! Steering Box for ‘71 LHD Bay- any ideas on replacement or refurb? Failed MOT on it. Cheers Stu

Out of interest- I got the Dell 40s used and had a strip down and clean, replace seals etc. However, on the manifold for no 3 cylinder there is a vac take off for the servo brakes. I'm assuming this may well be causing the issue? If so, what is the normal route for vac take off from the brakes...

Ok done that! Seems to only come back to 15 degree BTDC at idle0 that does not seem right... maybe the 009 is kaput? The DRLA on No 3 seems to also be popping..

Hi people I have just built a 1641, Engle 100, 009 with Twin Dell 40s. I've run the cam in but there is a fair bit of popping etc from what sounds like No 3 Cyl. I've dialled the timing in at 5 degs after TDC- but I'm wondering what the best timing point is for an engine like this? Anyone got...

Hi I wonder if anyone has experience of Auto Linea crankcases? I have been building a 1641 on one and got to putting the final cylinder (No 1) on. I went to turn the engine a full cycle and it jammed. After investigation it appears that the corned of No 1 was catching on the top on the case...

A-ha! Great. I've got a 1641 with twin DRLA 40s- was just going to use a 009- but then found all these.

Hello I'm trying to ID a few Dizzys I have lying around. I have; 1) JFUD4- 0 231 180 001- 211 905 205 S 2) JFU4- 0 231 146 101- 113 905 205 AL 3) JFUR4- 0 231 167 049- 113 905 205 AJ The thing is- when aligned for TDC on No1, all of them point to the No. position! (2 o.clock rather than 5...

Hi I wonder if anyone can help... I'm after; Complete stock 1600 engine (pref with no endfloat!) 200mm flywheel '71 Indicator stalk In Cornwall Cheers Stu

Hi all Got my hands on a nice pair of DRLA 40s for my 1641 (DP with Engle 100). They are choked down and jetted OK (unless anyone can share their wisdom on the best combo) - quick fuel pump question... is it best to run standard pump with reg, or new electric pump? Interested in people's...

Hi Literally the size of the lobe if you measure it from top to bottom with callipers. I want to know what the stock size is. Stu

HI- Yes, you are right- there are obviously loads running notched chassis! It is a bit of a grey area though as far as I can see. Mine is not notched at the front- only at the back. It has also had an MOT with it being like this- but what makes it legal without having to have an IVA test? What...

Hi all I have a ‘71 bus that is a bit of a resto job. It is from California and has decent body work and chassis.... apart from 1 thing! The chassis has been C notched at the rear to go low. I understand in the UK this attracts all sorts of complications with MOTs etc. I’d like to put this back...

Hi all Does anyone know what the length of a standard 3 rivet cam lobe should be? I'm after a second hand cam (rather than new chinese) and was interested in what the standard measurements of the lobes should be. Stu