Search results

Hi, looking to purchase a full set of the early bay two piece mountings which go between the mounting bar and the bus chassis if anyone can help it would be appreciated as the mounts I have don't fit and its holding me up fitting the engine now. cheers, Yorkieman

MG F 1996 1.8i vvc 86000 miles, MOT till mid October, new brake discs and pads all round, new brake hoses all round, catalytic converter, cloth/leather seats, convertible hood, just changed oil and coolant, suspension just regassed and all okay, no head damage or leaks. Full set of poly bushes...

I have fitted my thin plastic bush which goes around the steering lock part of the column its got a hole in for the lock to move in and out through but, it keeps slipping down the column and I find it around the base meaning of course that its then not isolating the column, presumably when I get...

Looking for one in good condition fully working.

Hi, I have a diverter valve fitted in the heater pipe to divert warm air to the cargo floor area but, it is missing the arm which actually moves the flaps inside the valve. Does anybody have either the a scrap assy with the movable arm or a complete assy to sell? I would appreciate any ideas to...

Hi, not looking for a heater but, the vents, movable, closable whatever and y or t piece joining pipes for the 65mm pipes any colour but, ideally grey or white or beige so eberspacher, webasto. whale or propex stuff should fit. If anybody has anything spare lots or only one piece I am interested...

Hi, I am looking for a front grill chrome surround in good condition.

Hi, I need the metal bracket for the side of the gearbox (n/s) which holds the clutch bowden tube in the correct position, would appreciate it if anyone could help. Yorkieman

Hi, At the front end of my main centre heater pipe is a junction which sends hot air to the walk through vents and to a hole in the middle of the cargo floor. This junction has a movable flap which is controls the air flow. Does anybody know where this is controlled from? Is it by cable from...

Hi, I have an Early bay small column (21 mm I think) and an ivory standard steering wheel, 2 spoke does anybody know if its a standard size horn button or are there lots of different ones? I want to try and a get a St Christopher button but, I am not sure if I would be able to get one to fit...

Hi, Looking for a genuine heated rear window or fog light switch , either will do. Thanks, Yorkieman

Hi, I am looking for a RHD outer sliding door handle with integral lock, not too worried about condition but, lock must work and have key too. Regards, Yorkieman

I have just bought this from cool air to replace my broken one, has anybody got the wire list for the new one so I can connect it to my van which is only a 5 wire set up? thanks, Yorkieman

Hi, I need either a complete RHD gear lever with locating pin and spring (not the large spring) at the bottom or the locating pin and spring on their own as I have a stick without them. thanks

Does anybody have a picture of the orientation of the said part for a RHD UK T2 with the door on the left side. I have a part but, I think it is for a LHD T2 but, having looked in the books I am non the wiser at all???

I know its a long shot but, I am looking for a set of bulk head trims, I keep missing the ones on ebay because of timing. If anyone can help I would be more than happy.

Hi, I need an inside front sliding door lock assembly and an outside locking handle with key. I already have the internal handle so don't need that.

Would appreciate it, if anybody has one for sale thanks.

Looking to get an inlet manifold with heat riser tubes, anybody got one they don't want? Cheers, Yorkieman