Air Shocks and Air Lift Kit

[retrokid]

Due to a change in plans I have for sale an air shock and control kit I have put together.
Kit includes:
Monroe MaxAir MA803 shocks (Compressed 10.5", extended 16.125") with adaptors to 1/4 dot (6mm) pipe
Air Lift load controller 2 (25804) kit.
Basically everything needed to install.
Everything is new and unfitted/untested. (Other than trial fitting one of the shocks)

Looking for £200

Can bring to Camerjam or deliver at cost.

 

[mr scoops]

Very interested (as I need a pair of air shocks)
I'll probably sell the rest of the kit on, assuming you don't want to sell the shocks separately?
I'll need to check my bus for lengths etc?

Are these going to work on a 4" narrowed link pin beam?

 

[Loxy]

Very interested (as I need a pair of air shocks)
I'll probably sell the rest of the kit on, assuming you don't want to sell the shocks separately?
I'll need to check my bus for lengths etc?

Are these going to work on a 4" narrowed link pin beam?

Might be interested in the kit for the right price

 

[retrokid]

I trial fitted one of the shocks to my 4+" narrowed balljoint beam and it fit, just.
I've since got machined lower arms and they would defo fit with them.
Not sure about linkpin, but there are quite a few air shock threads on this forum which may provide more info ...

 

[mr scoops]

I'll do a bit of research.
Assuming we both go ahead would you be prepared to split between myself and Loxy?
Could you PM us with prices?
Thanks Dude.

 

[bobbyt]

interested in the air shocks kit, can transfer funds via paypal tomorrow evening,
just a bit busy with work during daytime at the moment, let me know.
Thanks bob

 

[retrokid]

PM sent to bobbyt...

 

[monkeyboy]

If they dont end up having this i will pm me if it falls through !!!

thanks

 

[retrokid]

Very interested (as I need a pair of air shocks)
I'll probably sell the rest of the kit on, assuming you don't want to sell the shocks separately?
I'll need to check my bus for lengths etc?

Are these going to work on a 4" narrowed link pin beam?

Might be interested in the kit for the right price

Would rather sell these as a complete kit...

 

[retrokid]

OK, provisionlly sold to monkeyboy...

 

[ermhello]

can you please tell me where you got the the fittings from for the shocks, I have the same brand shocks and am struggling to find some anywhere. Many thanks

 

[retrokid]

sold sold sold...