My Pennsylvanian '67 Panel Project

[Smithy2801]

A long while since last update :shock: but a little more progress has been made
firstly chopped the arch off after deciding it wasnt worth patching due to the amount of patches required just to save a small amount of the blue paint.

Then chopped the steps and cut the floor section out but they will require a piece to join as the floor piece doesnt meet the inner step piece :? Also need a piece to go up the front of the wheel tub


repaired the small hole in the chassis

got the front and rear outriggers and the inner sill on and fully welded



Repaired the inner arch



And all painted in zinc primer just to protect till I paint the underneath

starting to take shape from what it was one section finally complete

Allthough not a major amount of progress I'm happy with what I have done and I'm slowly working my way around the bus getting it ready for and MOT :lol:

 

[Smithy2801]

Been a while since the last update :shock: but still slowly working my way through and getting better with the welder :lol:
Progress since last time
Floor section,inner step,outer step, inner arch repaired, outer arch



Cargo floor repaired above inner sill and inner sill welded too it

just the side panel and rear arch to go on this side then the same again on the other :lol: