creationblue

Yea I replaced both doors, the ‘68s didn’t go on, one is a wall decoration in my studio and the other went up to Adam & Hannah to help...

You do have one of each don’t you? I seem to remember you needed a replacement door and you bought a pair of ‘68s.

My front end still wears the scar where said over rider made contact with it after a collision in the distant past

I think they add a little protection from those folks that park too close too

That is a possibility 🤣

I reckon the wind forced that one wide open!

Mine came with over riders but I’ve taken them off for delux trim but I’d happily swap back as I think they look cool

Well, I’ve only just noticed this after all these years! I have one of each. Drivers door opens 90degs whist passenger side doesn’t...

I changed my bushes a couple of summers ago and tbh the original ones were much better than the repro one I replaced them with. If I had...

The original Red9 kit I had was ok, but the handbrake on their billet calipers is not strong enough for a heavy bus and I ended up...

@Bundy may be able to assist

It's a whole can of worms, there are a few options, nothing particularly cheap. That bus in the add is pretty low to be fair and I would...

If I didn’t have nitrous on the bus I’d put the mag on that. But I need the ignition ECU to control the gas and pull the timing back

Your ‘ horde ‘ looks so flippin tidy and all real good stuff too. Mine is just stuff, good stuff, not so good stuff and just stuff...

Yup, I collect (horde) stuff….. I also have a penchant for Mallory ignition stuff 🤦🏻 Brought this NOS magneto earlier in the...