porsche wheels on 205pcd

[tonicman]

looking for some advice here does anyone run porsche wheels with adaptors, do they fit under the arches easily if so on rear, also are later hubs and spring plates the same dimensionally and interchangable as if i go for later hubs and have em drilled for porsche i already have 68/69 adjustable spring plates and intend to use them, front not so mucha prob as i am running split beam so can get dropped porsche spindles

 

[dagboyblue]

what you putting on - the offset is the key

 

[tonicman]

am putting gas burners on think they are mws ones

 

[dagboyblue]

i would say the offset would need to be at least 52et if you are using adapters if you are drilling the drums to a porsche pattern it will be less of a issue

i'm running teledials on my bus and 928 flat dish on my truck both sets are on adapters and they have a offset of around 60et

the adapters are 25mm and the wheel fit in nice

 

[tonicman]

these are et35 just looked so might be tight where did you get adaptors from and how much please

 

[dagboyblue]

i guy off ebay,think he is on volkszone too,

i will see if i have the link

also, if memory serves me , slammedresto had a prob with mws gas burners and rear adjustable plates on his ex van

give him a pm

 

[AxlFoley]

I dont think et 35s wil fit, although that depends on how wide they are, if they are only 5.5" wide you should be ok.

Mark

 

[tonicman]

i think they are might use my mates adaptors and see if they fit as i had wheels anyway