sharman
Well-known member
I have a rock solid standard lhd front beam with Servo mount and slamwerks adjusters.
The unfortunate thing is that an expert fitted the adjusters and managed to make a mess.
Weld had penetrated the adjuster and onto the collar, making it very tight to rotate
I've had to remove the weld on top n bottom of the adjuster to free off.
The bump stops have been removed.
The beam itself is absolutely solid and I have coated in por15. I also replaced the swivel pin.
I have run with this beam fitted without any issues.
Asking £150 or best offer
The unfortunate thing is that an expert fitted the adjusters and managed to make a mess.
Weld had penetrated the adjuster and onto the collar, making it very tight to rotate
I've had to remove the weld on top n bottom of the adjuster to free off.
The bump stops have been removed.
The beam itself is absolutely solid and I have coated in por15. I also replaced the swivel pin.
I have run with this beam fitted without any issues.
Asking £150 or best offer
