Search results

I got mine from Peter at Volksgood s, I know he has retired but he sent me one last week and a very good price. Maybe he stock to clear or honoured our conversation at the back end of last year.

This still happening Carl?

Alternatively if you go to any shows these things are everywhere. I got mine from MCJ Products.

As far as I know they don't exist to buy. I just used some draught excluder stuff from B&Q

Bugger, bargain that!

GB 6750R for me please.

Hi Bazza, I presume this doesn't fit in an early engine bay then? thanks Mark.

PM'd

The eBay ones I bought are from julia4944 but there are none showing at the moment. Fit fine.

I was told the original had a split on the bottom. I did this on my repo one and it makes getting the valance out easier!

I've got some handles but no barrels if that's any help. They are the later early bay ones not the push button early ones.

There was onOnondaga eBay a few weeks back. I'd give FBI in Swansea a call as I think it was them. Also Rusty on here has a couple of busses coming in I think. See the early bay parts thread for his advert.

The bettle ones have the arm on the inside and they are extended down about half way. The bus ones are on the outside and sit on the pivot. I got bettle ones and have had to wire them open. Oh and the heat is awesome, I have to drive with the window or the flaps open! I'm even considering...

I had an MOT a couple weeks back with no emissions test. I took it to the garage that Pete Nice uses so they are probably aware of the above rule quoted.

I should have checked the website! Email [email protected] :D

Hi Alex, hopefully this isn't bloody obvious but is there anywhere I can sign up outside of Facebook as I don't use that. Thanks Mark

I can't see from the part number what bit you are referring to but is it the bit that the cables bolt too? if so, I made one out of the pins that you use on axle stands.

This was one of the most irritating jobs I've done on my bus. The first one took me about 2 evenings, but now I could probably do the whole thing in 15 minutes. Haven't read the link but I did follow one. the bit that's hardest is the scraper clips that go in the the door. Easiest way I found...

May or not be of no help but have you taken the calipers off at all? I out my new I rd on the wrong sides so the bleed valves were at the bottom. Swapped em over and hey Presto! Also, I recommend one of them pressure system bleaders.

Either on here or eBay I'm sure FBI in Swansea are selling a complete rear chassis from the torsion bar if that's what you're after. I'm going to take a complete guess at £350.