Search results

Hi I have some used T2D coilovers £25 if you want them

I’ll be selling my vintage speed super flow system in the next couple of months, has less than a 1000 miles on it

Hi all, can you show me some photos of where you mounted your tachos? I don't really want it on the top of the dash. Thanks

I will take it if you still have it

Ok thanks will check them out

Hi all, need to change my oil soon been about 2000 miles, I am going to use millers cfs 10W40 but when it comes to external oil filter what do people use? I currently have a K&N but it just looks a bit boy racer. The only high pressure ones I can see on sale are empi or fram, reading the...

I used our bay for our wedding 2 years ago and done a wedding for a friend yesterday. I actually enjoyed doing it and am now also considering doing a few weekends next year. Not looking to get rich off it just help pay for the upkeep of the bus.

Have you got any photos K@rlos? Do you have a deep sump fitted?

I should have put a bit of info on the engine I also have quite a well specked 2110 so have the deep sump for the same reason as you. There is a good write up on gene bergs website about the benefits. I don't really want to take it off and I don't want to raise my bus, I was tempted to see if...

I went down 2 splines on the rear. The only thing I really worry about is any debris in the road or potholes and speed bumps

Fitted my new engine a few weeks ago and it does worry me a bit at how low the deep sump hangs down. Has anyone got a similar set up without any issues? Or should I look at getting it removed

I backed off both adjusters but the bearing was so shot I think this is what is stopping the drum coming off. I am hopefully getting my hands on a hub puller this week so will try that

Hi guys my front wheel bearing is shot, I have backed off the adjusters and hammered the shit out of the drum but it's not budging. I don't have access to a puller and don't want to spend loads on buying one. Is there a diy trick I can do to get it off? Unless anyone lives in Cambridge that I...

I have one kicking about somewhere in Cambridge

Can I ask why you changed them? How do they perform? Thanks Lee

I'm in Cambridge bud, bit to far than less you go to any shows?

I have a 3/4 bluebirds rock and roll bed and covered foam with not much use. I have decided I don't want units in my bus so looking for a full width bed Thanks Lee

Not a bad idea I did wonder about mounting on the top of the tin before I put the engine in but though it might be difficult to adjust at that height. Might do it like you but put a bend in the bracket it comes with so I can see the gauge

Hi guys, just upgraded my engine to a 2110. I have fitted a red top facet fuel pump under the tank but can't decide where to mount my malpassi regulator? Anyone else using one of these any photos would be great. Also looking to mount an external oil filter by the rear wheel...

I have used Andy Raw down at Tsr not for a scooby conversion but for carb rebuilds and tune up. Really nice guy fair price too. Would happily use him again. Hope this helps