Calling 68 Westy Owners.

[Graham L]

Hi Guys

If you own a 68 westy is it possible you could measure the length and width of the plastic top of your sink unit please, been asked to check some measurements for someone and dont have a 68 sink unit available at the moment

(only from a 68 with the plastic composite sink & top, not the stainless steel ones fitted to later buses)

Thanks guys

 

[67westy]

Graham, I've got a reproduction one made by Ron that I can measure at lunch, will that be any good? I think I have the original as well but it isn't complete so measurements will be tricky

 

[Graham L]

That would be good if you could Adam, there appears to be some discrepancy about the actual dimensions

 

[67westy]

Ok mate, will take some pics as well. Should be done around 1pm

 

[Clem]

Adam - The repro tops that you and I have are slightly different from OG - the edge lip/depth is different for sure.

My original top is at my workshop, I can get some measurements off that later this week?

 

[Graham L]

If you could Mike that would be great, its the actual measurement of the top surface edge to edge I'm after.

 

[67westy]

AHh ok then, will not measure the repro one. Will see if I can find the original but it wasn't in great condition

 

[67westy]

The one I have is 48.5cm x 53cm but its not in the best condition..pics to follow......

 

[67westy]

 

[Graham L]

Hi Mike

Any chance you could measure your sink top as could do with accurate dimensions of the top surface, cheers

 

[Clem]

I make it 49 x 53.5 x 2 cm

 

[Graham L]

Brilliant, thanks Mike

 

[Clem]

If you need a closer look I can bring it to DTA?