Chrome Dash rings

[joneastwood]

So I have bought a set to brighten up the dash board

The problem is the rings are flat yet the dials rims on the dash are slightly curved so they don't sit flush

Who has fitted them and if they did what did you do to make them fit/sit flush and stay in place?

 

[lemur]

If I remember I think I carefully bent the by hand (steady as she goes) and just a few drops of hot glue from the gun on the inside, I thought the quality was somewhat questionable tbh, but ''they are what they are''.

Hope that helps a tad,
Liam

 

[Bobster]

It’s been a while since I bought mine but I thought that they came with instructions that talked about rolling them over a pencil or something ?

 

[gas1man]

Done this in the last 6 months and did a dry run first . Yes they are bent but if you slowly turn them around
they eventually get to a point where they are pretty flush. Now a touch of glue they supply you with and
once in place , I placed a cloth covered brick :lol: carefully on top of each one . The weight held it all down and
the next morning job done. Was a bit Heath Robinson but they are still in place . Hope this helps. I was to scared
to bend mine by lumpy hands and feet. :lol: :lol:

J & P

 

[Rikki James]

Where does one get these things from?

Cheers

Rikki

 

[lemur]

Like everything.... eBay :shock:

https://www.ebay.co.uk/itm/114373878354

Liam

 

[gas1man]

https://www.ebay.co.uk/itm/VW-T2-Camper-Bus-67-79-Aluminium-Polished-Chrome-Dial-Rings-Set-Of-3-New/222312746244?hash=item33c2df4d04:g:0IAAAOSww9ddmjxr

Another to just check out. I also found two , one for each air vent.

J & P