Hi Guys
Been working on our 72 Crossover and stripped the front panel, shouldn't have looked!!!!!
anyway found some nice fillered over accident damage and rot under the window rubber in the corners ,this has gone through to the inner top as well,
looking at options, isee you can get various repro fronts and fab it to make it look early but they all have a raised plinth for the badge, i'm thinking the best bet would to try and get one thats been cut from a californian bus? would that be the best route? and would you fit it complete as an inner and outer rather than unpick all of the spot welds?
i would be grateful if you could point me to any links showing this job, any tips appreciated as well, thanks in advance.
Been working on our 72 Crossover and stripped the front panel, shouldn't have looked!!!!!
looking at options, isee you can get various repro fronts and fab it to make it look early but they all have a raised plinth for the badge, i'm thinking the best bet would to try and get one thats been cut from a californian bus? would that be the best route? and would you fit it complete as an inner and outer rather than unpick all of the spot welds?
i would be grateful if you could point me to any links showing this job, any tips appreciated as well, thanks in advance.


