gr00veg0d
Well-known member
- Joined
- Aug 4, 2012
- Messages
- 146
- Reaction score
- 0
Just picked up a set of jge raders for my bus .
When I hold them against a front hub they stick out a further 3cm(ish), the casting mark on the wheel says et+20.
The plan is to go dropped spindles so I'm thinking I'll have to fit a narrowed beam?
Before I go down this route can i ask is anyone out there running a similar setup on a stock width beam?
CheersCheers
When I hold them against a front hub they stick out a further 3cm(ish), the casting mark on the wheel says et+20.
The plan is to go dropped spindles so I'm thinking I'll have to fit a narrowed beam?
Before I go down this route can i ask is anyone out there running a similar setup on a stock width beam?
CheersCheers