New arrival :) 1970 camo

[lil_azza]

Cheers buddy i will check but it only jumps to full if i put lights on :/

 

[lil_azza]

So iv got a big mondo on atm and want somthing a bit more descret i have this bit think its a the larger bore but would it be ok coupled to this twin kadron? Was gonna cut one side off n blank it over? Or would that be over kill for my 1500?



Failing that i have a beetle gt twin tip but i could never get my beetle to run right with it on might have just been cocindence tho??

 

[lil_azza]

So me n dad pulled mostly all wires today and started again got it done now hopefully, tries to run just won't :/ oh we'll sure it won't be long, need to order floors soon so it'll finally take shape
Don't feel like much is happening on it ATM

 

[lil_azza]

It runs!!! Wooop hell yeah!!!!! And runs very very nicely too
Now just gotta figure out why when i turn key off it still runs as i still have power from the coil, guess i have a ignition wire wrong somwhere?
Any had this yet?

 

[lil_azza]

Not thats anyones intrested but sorted the wiring gotta fit handbrake mount today because PO cut old one out :/ if rain stops or if not irl flash band the roof and fit the heater lever mech back in,

 

[gninnam]

I'm interested
Glad that you are still moving forward and making good progress :mrgreen:

 

[lil_azza]

Cheers gninnam so did abit today i had this horrid patch
so i cut it out


Ready for me to zip a new piece in next week

 

[lil_azza]

And i had my little boy helping he loves it

 

[lil_azza]

And i had my little boy helping he loves it

 

[lil_azza]

And i started stripping the original paint hopfully it will look ok in the end

 

[gninnam]

Hope you are paying him a good rate

 

[lil_azza]

Haha our arrangement is I buy him a new small car every shop visit :/ we'll he's arranged that lol

On the other hand I've also cleaned up a set of heat exchangers that I think I may be able to salvage
Or I have another set but the bore size is considerably smaller :/ guessing there 1200 ones

 

[Kosytoes]

Love the van dude!
ps The bars would look ace on that!

 

[lil_azza]

So today I put a new torch on the welder, so surprised how bad my last one was
And did a bit more paint scraping went a bit deep but it's fine it shines up great

 

[lil_azza]

 

[lil_azza]

So did abit more this weekend i gotta clean the welds but u get the idea

 

[gninnam]

Doing good - keep at it

 

[lil_azza]

Cheers man, will order floor pans in the next week or so, hopefully the will go in easily

 

[lil_azza]

Make a cheeky little order today
And painted the floor also cut a small repair needed in wheel arch

 

[lil_azza]