Removing handbrake cable from brake backing plate

[logicred]

I have removed my rear hub from my '69 bay. I then unhooked the handbrake cable from the shoe lever, but I can't figure out how to remove the cable from the backing plate. There is no visible 'clip' that I can see. I have seen this post which shows TWO pictures:

http://www.volkszone.com/VZi/showthread.php?t=725064

Which side is this 'clip' supposed to be ok, the inside face or the outside face where it enters the backing plate?

Thanks

 

[sparkywig]

There's no clip, the cable sheath pulls straight out of the backing plate.
Use a bit of penetrating fluid and twist it out using some grips.

 

[neilswheels]

I have 'clips' on mine, it is a 71 tho. They go on the inside of the backing plate and are slid in to the spring around the cable as it comes thru the backing plate, basically a flat disc with a slot in it.

 

[*Sam*]

I have those also my bus is a 70