Thanks Lee C and kevinhall
So, more making holes to fill them in again today!
I couldn't face removing the engine and fuel tank to replace a dodgy sender, so a hatch was required. I used some of the engine access hatch that I chopped out to make the frame around my cut.
Then see how it looks. Cool. Just needs some rivnuts in the holes and some seam sealer
In other news, a bit of a measure before chopping up the sound deadening panels...
Then make good the bottom of the 'C' posts and slap on some rust preventive primer where the bulkhead has been repaired above the cargo floor
Then off home for a beer in the sunshine, followed by a curry!! arty0021:
So, more making holes to fill them in again today!
I couldn't face removing the engine and fuel tank to replace a dodgy sender, so a hatch was required. I used some of the engine access hatch that I chopped out to make the frame around my cut.
Then see how it looks. Cool. Just needs some rivnuts in the holes and some seam sealer
In other news, a bit of a measure before chopping up the sound deadening panels...
Then make good the bottom of the 'C' posts and slap on some rust preventive primer where the bulkhead has been repaired above the cargo floor
Then off home for a beer in the sunshine, followed by a curry!! arty0021: