Search results

Will seats from a MG ZS or rover 45 fit an Early Bay? Tried Saab seats and they make me sit too High!

Does anyone have any advice on how to get the vertical section of rubber in the groove? I have riveted the two parts of the metal frame together and partly installed the rubber on the "C" section but the last bit is beating me!

I have a 1969 Tourvette petrol tank but no breather pipe! Anyone know where I can get one? I am also after an alternator stand like this

Been cleaning the engine as it was out (well in fact it has not been in van since we purchased it over two years ago!) and I had to drill out the Fuel Pump Flange which had snapped off inside ! ( I tried tap it then insert a bolt first but no joy). So decided to clean - and I noticed that one of...

Been stripping the parts off the engine to clean it up and paint the tinware - unfortunately a number of the bolts snapped off. What do I do?

Just going to order new copper brake pipes and male/female connections and a three way joint for the rear where the single pipe from the master cylinder splits to go t the two rear wheels. I went under the van to check and spotted these two three way connections just the other side of the...

A selection of new unused parts left over, selling for a friend. Collection only or can Bring to DubFreeze. Items are as follows (open to reasonable offers or sell as a whole):- Nearside door skin £35.00 Early Bay nearside front wheel arch £50.00 Late Bay nearside front wheel arch £60.00...

Just purchased a 1969 Torvette early bay( according to the badge inside) the Pop Top is incomplete and has the essential hold me up bits missing! The trimming of the roof opening is very strong with a section of timber on top of the roof bolted through to an angle iron internally sandwiching...

We have a 1971 Early Bay which we have done up over a seven months period and have been out in her three of four times this summer. The original seats were not original and the runners non existent. So we installed a pair of Astra GTE seats ( which are a Recorro type), however whilst head...

The oil filler neck is loose on my Early Bay - a bit of green stuff between it and the main neck came loose and fell off and the neck now wobbles around - what should I use to secure it or seal it?

We are in the process of refitting our bay and we have decided to construct a new "kitchen" unit In which we will have a sink hob combined unit on top (Smev 8862). Underneath we will have the waste water and clean water containers. Next to it ( still in the unit) will be the propane gas bottle (...