deluxe beltline trim

[andewilson]

hi guys i have a deluxe beltline trim going spare. i bought it two years ago from vanfest from one of the dutch guys who comes each year.

it is original and comes complete with all screws and clips. it is off a lhd van. and is all complete. my bus is rhd, the difference is tiny and it can be fitted to rhd but as my bus is now shiney paint i was going to repolish it and strip it back etc so i may aswell buy a repro rhd at the usual scene tax cost :roll:

i will try and take a few pics when i get around my workshop but it is basically still packaged as i bought it.

£120

i will be at busfreeze

 

[clyde]

Whats the differance fella? The repo stuff can be a dodgy fit. Mines got a few dings now from being polished by some complete **** so i might be interested. Whats the condition.

 

[andewilson]

hi jon, the bits that go on the sliding door track cover has a slight angle to it that is obviously on the other side if you have rhd to lhd. i will dig it out in a bit and check it all over and hopefully take some pics

 

[clyde]

Ive never noticed any angles, are you sure your just not getting in to deep.

 

[RICH-I-AM]

Keep the original rear corners and polish em up. The aftermarket ones DONT fit properly!!!
I only found this out when i fitted all new kit for the sum of £260. Then had to sourse 2 OG corners.

Rich

 

[Gadget Boy]

Ive never noticed any angles, are you sure your just not getting in to deep.

No John, there are several angles punched into the trim , so it fits on the rear corners i.e the sliding door track cover to the rear corner trim and the rear of the sliding door etc . If you put a lhd /rhd kit against each other its quite obvious TBH and trying to mix an match a set to an opposite driven van it will look weird

 

[andewilson]

exactly why i havent gone for stainless dean . ideally i wanted the stainless polished trim but think i wil have to try the jk stuff.

 

[AGC]

Havent heard back from you mate.... (see pm)