Doorcard membrane sealant

[Moseley]

Pretty straightforward one really. I've just finished cutting some new door cards and going to knock up some membranes to suit shortly. I was wondering what people use to seal / stick them to the doors?

The only experience I've had with something similar was on my old Rover, and they were fitted with some non-setting black gunk stuff. Messy ****, but did the job and could easily be fitted / removed repeatedly. 8)

Any recommendations?

 

[mike202]

I used some low tack double sided tape to stick mine. It's just not as messy as spray glue.

 

[Moseley]

Not a bad shout - maybe some thin number plate tape would suffice?

 

[the_troupster]

I use hi tac fix all.

 

[Bluesnailman]

if you want to seal the back face of them - i'd recommend you get some pva and a roller. look at the instructions on the tub and water it down to suit.

Works a treat on freshly plastered walls to create a waterproof/repellent surface.

You also want some plastic liner (B&Q?) in there too, remember to tuck the lower edge inside the door, that way any water that hits it will remain inside the door and will come out the drain hole at the bottom/rusty hole at the bottom (delete as appropriate)