Fitting new floor pan

[Lobelowe]

Can any one help with advice on this/ how hard it is? Is there a thread or how to? Just thinking about doing the drivers section as it has a little rust while the van is stripped down. Anything on battery trays also??

Thank you.

 

[lil_azza]

Just done it. I would say the fitting was easy the removing of old was a paint take it easy and slow you will be fine

 

[Lobelowe]

Thanks for the advice
Where did you get your replacement panel? Did you drill out the spot welds? Any further advice would be welcome. Not too sure how and where it is held in?