I have just upgraded my generator to and Alternator which went quite well until I found arm on the right hand side off the carb hits the alternator edge as it comes down to full throtle.
As in pic below there is a nut that goes through to plates and it appears to be the nut that hits the alternator.
Can anyone tell me the best wat to solve this so I can get full travel on the accelarator pedal/cable? do I try and bend it or cut it off etc.
Any help much appreciated.
Simon
As in pic below there is a nut that goes through to plates and it appears to be the nut that hits the alternator.
Can anyone tell me the best wat to solve this so I can get full travel on the accelarator pedal/cable? do I try and bend it or cut it off etc.
Any help much appreciated.
Simon
![carb.jpg](https://proxy.imagearchive.com/42e/42e5aa245567f8af69fbf267a6b49c77.jpg)