mr scoops
Well-known member
- Joined
- May 8, 2010
- Messages
- 1,144
- Reaction score
- 0
Last little jobs on the new engine build and I want to install the distributor drive shaft.
Heritage says I need 2 x 0.6mm shims
CoolAir says I need 3 x 0.6mm shims
What size are the c clips needed to hold the linkage on the flaps in the fan housing? Looks around 4mm inside dia to me
Heritage says I need 2 x 0.6mm shims
CoolAir says I need 3 x 0.6mm shims
What size are the c clips needed to hold the linkage on the flaps in the fan housing? Looks around 4mm inside dia to me