Lots of early bay stuff engine chassis lights etc

[shroom]

Lots of my last thread has been sold so here is some new added stuff up for grabs

Crew cab roof £200

Front chassis happy to cut up for couriering £130

Middle chassis happy to cut up for couriering £60

PM me about any body cuts you need

RHD gear stick with extension £25, £30 posted

Pair of Crew cab gate locks £25, £30 posted

Horn £5, £8 posted

Totem £20, £25 posted

Very straight front bumper £120, £135 posted

Front bumper irons £25, £30posted

or bumper irons and bumper £135 £150 posted

RHD windscreen wiper mech £45, ££52 posted

Rear crew cab door, welded on lower section but pretty good £45, £58 posted

Uncut metal RHD dash £65, £78 posted

Pair of Custom door pulls (3 shown) £6, £8 posted, winders £8, £11 posted

Petrol tank £55, £67 posted

Rear gear stick connector rod £25,

RHD Steering box NO idler arm £80, £87 posted

Shroud including non-standard barrel and key £20 Posted £25

68 bolt on (not grub screw) Windscreen wiper arms £12, £15 posted

Not so good rear valance £40 (£50 posted)

New 68 clutch cable £5 £7 posted

Engine compartment stay £8, £10 posted

Brake peddle and linkage £15 £19 posted

Clutch peddle and linkage £15 £19 posted

Left and right inner cill £30

Left and right outer cill for a crew cab £30

Pair of brand new hella front headlights £125, £135 posted

number plate light cracked platic but that is over where the metal is £17 £20 posted

westy fold down table £10, £15 posted

Plastic ventilation tubing, all pieces (the stuff that connects to vents etc) £20, £25 posted

1600 Twin port 10k miles, alternator, carb and stainless exhaust new at 10K Ready to bolt in £950.

RHD early bay wiring loom, needs attention to one part where has melted insulation where welded £45 £52 posted

Front brake spring retaining pin repair/rebuild kit £8 £10.50 posted

Crew cab rear window £40

Oilbath air filter £25 £34 posted

Pair or wing mirrors one no glass £10 £15 posted

Or pick up from East Dorset (Christchurch near Bournemouth).

E-mail at iaindhill at yahoo.com

Phone 07904577725

Cheers

Iain

 

[tomedwar72]

Hi there, I'll take the front bumper posted, pm sent.

 

[shroom]

pm replied

to

 

[Beigebay1968]

Hi bud would you sell header and muffler off the engine?

 

[Resto-raider]

I believe the shroud is already on my kitchentable. Thanks for the fast shipment Iain. Royal mail was pretty quick as well.

 

[OLIVE-BAY]

hi would u sell me the gear stick extention and ball? posted please

 

[james_stan]

Hi there

I'm after an inside body cut for the rear of the cargo cabin in a bus (not piuckup). the bit I'm
after is described in this post can you help ?
http://forum.earlybay.com/viewtopic.php?f=4&t=31378

Cheers

J S

 

[shroom]

hi JS
the section where the rear diagonal downwards touches the floor is toast *(one of the reasons why van was scrapped) however have the diagonal downwards pannel is ok from 2 inches from floor if you could use the metal. Otherwsie you need to make something bespoke to fit as others have done on your thread hard work but that is the only solution that i can see sorry as no panels are avalible although try musclebus or indeed schofield do do one off's

SOrry

Shroom

 

[james_stan]

Hi Shroom

Thanks for reply. I'll check it out again. As you say may be some
of the metal of the right corrugation ca be adapted.

Cheers

JS

 

[shroom]

i can cut the whole corrugated section out, from wheel arch to wheel arch no probs.

Shroom

 

[lilblue1970]

I'm after the rear upper shock mounts, if they are in good nick and you want to take the off the chassis rails. Cheers.

 

[Happystamps]

what's your best price posted for the inner sills?
cheers, simon

 

[shroom]

as postage for cills is £12 (length once packed 155cm) then £37 posted or £25 and you get your own courier


Happy to cut from chassis the shock mounting.. i cannot rmeber if bum stop is same place as upper shock mount. If so i have already sold the earside on The off side will be £25.. if you have a pic i can tell you if i have it as away at mo

 

[james_stan]

i can cut the whole corrugated section out, from wheel arch to wheel arch no probs.

Shroom

OK sounds good. Whereabout are you ? I travel about a bit with work so might be able to pick-up as it's quite a big piece.. Oh yes how much ?

Cheers

JS

 

[shroom]

i live in christchurch which is 5 miles east of bournemouth and 18 miles west of southampton. I have no idea how much i suppose it depends on how much you want. CAn you put a photo up for the section?. If it is just the flat bit with the corregation then post would only be £10 and perhaps £25 fo the section. But if you want alittle more then it would cost a little more. Tell me if you think i am taking the piss!


Shroom

 

[james_stan]

NOt my van but this picture (yellow circles) shows the rotten areas.

Not in any great hurry for this since I need to find time to remove engine, fuel tank etc.
which is tricky with my nagging Mrs. :roll:
TBH I think just a couple of cuts 6 " x 12" would do it, but I will measure again.

Thanks again

JS

 

[shroom]

no problem. i will cut from wheel arch to wheel arch from about one inch above floor (as toast below) and cut into two to reduced postage

Iain

 

[shroom]

bumpers now sold


Any offers on anything else

Shroom

 

[biggles]

what year is the air cleaner for, my bus is a late 69

cheers biggles

 

[shroom]

is a g reg so that is 68/69

shroom