Rear Bumper attachments

[ghop99]

Other than the irons in the middle what are people using to secure the ends of the bumper to stop it sagging? I have seen some leaf/crud catcher things on JK but is there a ready made bolt that can be bought to tie it in to the wings?

Cheers

 

[panalvan]

The bumper should have splash pans on each corner these tie in the bumper and stop it bouncing.The pans are attached to the bumper iron on the top by a 6mm bolt and nut and to the bumper using the last bolt hole on the bumper.It also bolts to the van on the underneath on the lip under the rear corner by a 6mm bolt and nut .There is also a rubber seal that goes between the bumper and spash pan.It also bolts through the pressing on the rear corner using a 8mm bolt and nut.Hope this helps