GreyPrimer72
Member
- Joined
- May 8, 2008
- Messages
- 16
- Reaction score
- 0
Hello,
I am just after a bit of advice on my threaded sump plate, the part that is attached to the engine. I have seen that you can buy 8mm to 6mm stepped studs, then tap an 8mm thread in the threaded hole, but i cannot find this stepped stud anywhere. I have called my local engineering places and they don’t have any, and i can’t find them on any of the online parts retailers.
Does anybody know if this is the best way to go about fixing the problem and do you know where i can get my stepped stud?
Thanks again.
Graham
PS: here is the link to a simmilar discussion on JK http://www.justkampers.com/forum2/viewtopic.php?f=15&t=158637
I am just after a bit of advice on my threaded sump plate, the part that is attached to the engine. I have seen that you can buy 8mm to 6mm stepped studs, then tap an 8mm thread in the threaded hole, but i cannot find this stepped stud anywhere. I have called my local engineering places and they don’t have any, and i can’t find them on any of the online parts retailers.
Does anybody know if this is the best way to go about fixing the problem and do you know where i can get my stepped stud?
Thanks again.
Graham
PS: here is the link to a simmilar discussion on JK http://www.justkampers.com/forum2/viewtopic.php?f=15&t=158637