Westfalia Buddy seat help

[AxlFoley]

I am about to recover the buddy seat in my van, but when I bought it, it just had material wrapped arround it, so I'm not quite sure how it should look, I have taken photos of my seat, I can understand teh poppers arround the top and sides, its just the base poppers that are confusing me, they look like they are in the wrong place, but they are deffo factory originals.

Has any one got a photo of how the bottom of the original fabric attaches to the seat itself?

This is what I have

Is this board supposed to be there ?

p.s. sneaky peak of my new seat covers!

 

[Dolly Daydream]

There should be 4 poppers on the seat base from new yes , and the cover has the female poppers on which just fits to them, like this one . I can take a underneather photo for you tomorrow.

 

[AxlFoley]

The only poppers I have are the three shown in this photo.

if you could take a photo of the underneath, it would be much appretiated.

Thanks

Mark

 

[Dolly Daydream]

This is an OG one which is in for re-trimming, it should have a black stopper underneather on the front .There is a popper on each of the 4 side's, the staple's have been added by some one later.

 

[AxlFoley]

Hello

Thanks for that, but I think something may have been lost in translation, what I was after was a photo of how the back/ upright cushion attaches to the seat.

Thanks

Mark

 

[faux]

There are normaly poppers that run along the top too.