Search results

Random question, I'm looking to make a replacement worktop and ideally want to match it the same pattern as the devon table tops. Stan, when he ran Camper Interiors, used to sell the correct laminated panel board but the website no longer shows it as a product. Has anyone found an alternative...

Annoyingly on one of my Devon roof bunks, one of the two bolts that holds the rear scissor bracket to the side bulk head has gotten lost The top bolt appears to be around a m8 but I can't quite work out what size the bottom bolt is. The thread is too tight for a m7 bolt and I don't want to...

I've still got the original 1971 Devon moonraker cool box (and interior) fitted in my van but the plastic inner panel attached to the cool box door has some damage and glue just isn't cutting the mustard anymore Anyone know where I can get a good quality replacement or second-hand part ...

Hi I did a post a number of years ago looking for the exact type of Veneer used on Devon early bay interiors but never been satisfied with the results so looking to do it all again. Therefore can anyone advise on The type of veneer used ? The stain used on top of it ? Many thanks in advance

Hi I am looking to get a 1970s white dudley cooker rebuilt (the type in the swing out devon cooker assemblies) and wanted to know if anyone knows who can remake replacement cooker spindles ? Many thanks in advance

I have an old Dudley cooker and grill in a swing out unit that has developed a fault (see earlier posts) and as I can't find spares for it I do need to replace it with a similar sized unit. Any recommendations on what and where I can purchase from? Many thanks in advance

Hi I am looking for a replacement gas controller for a 70 swing out Dudley cooker as used in a moonraker conversion. It is the controller in the middle that turns the grill on or off, anyone have one in fairly good condition

My speedo, works fine until approaching 55 mph when the needle moves up slower till it just stops at 55 Started out of the blue a few weeks ago and looking for advice on cause , fixes or where to get it rebuilt. Jacks garage checked the cable when she was in and no problem there so very confused

Can anyone advise, my 70 bay started running like a pig with asthma last weekend on the way to volksworld and I assumed it was weak fuel mixture due to the cold But this weekend, slightly warmer and still the same problem. They are standard carbs on a 1600 engine On inspection there appears...

I have a problem with my locks at the moment whereby I have to jiggle the key for a while to get them to unlock or lock I remember reading somewhere it is possibly down to a worn spring in the lock mechanism causing the problem but can't find the article or remember where I saw it Can anyone...

I have been trying (unsuccessfully) to get a Devon wardrobe (the one behind the drivers seat) for a while so have now drawn up a template from a friends and will get one built over the winter However I am not sure which veneer was used on the original Devon interior parts Can anyone shed a...

Hi I have now realised that to bring my bus back to origional spec I need to get hold of the following items Right Hand Drive Devon Interior: Wardrobe (as sits behind the drivers seat) with buddy seat Compactum (as sits behind the passenger seat) with buddy seat If anyone has these (or...

I am looking for the Devon wardrobe unit that sits behind the drivers seat, I have a buddy seat that slots into it already so just looking for the wardrobe unit Many thanks

Good afternoon Does anyone know of a good alternative to the disklok steering wheel device as their largest product fits wheels up to 44cm and as you may know a bays standard wheel is 45cm (go figure) I am looking for additional protection to the standard alarms / immobilisers out there...

I am looking for the buddy seat and wardrobe combination that sits behind the drivers seat on a 70 Devon Is anyone replacing an interior and has one of these for sale ? Many thanks

I am in need of the two pairs of interlocking metal sliders plus fittin kits for a 1970 Devon original bed Can anyone help and point me in the right direction Many thanks

Had a few wiring problems since the alarm guy put the system in to our new rebuild, and I now need some advice. I had a problem with the headlights blowing the number 3 fuse (full beam) which appeared to be down to a loose wire (the wire to the back of the instrument panel was off hence the...

looking for 2 or 4 black draw handles for a 69 touvette conversion as these are the last parts need to bring the interior restoration to an end anyone got these just sitting in a draw or a tired interior that they are scrapping ? look forward to hearing back

Hi - we have just restored the devon interior for our 69 bay, and sadly the garage threw away the doors when they rebuilt the bodywork (the doors were rubbish lets face it) and in doing so we lost the plate on the door added by J,P, White when they did the conversion Has anyone got a good...