Door card pain in ar@e

[Shoddy]

Hi,

Has anyone found a way to keep the cab door cards in place? I fitted new ones over a year ago now using new clips and bungs but they constantly pull back out of the holes.

Cheers
Craig


Sent from my SM-G955F using Tapatalk

 

[Moseley]

Definitely the right size clips and bungs as these have been known to have been supplied incorrectly in the past? Beetle ones are larger I believe, but you would have to have had the door holes drilled larger to accept them. Can you measure your holes? And post a link to which clips and bungs you’ve used?

From memory, I purchased all mine from JK and fitted with new door cards, had no issues. You definitely pushing them on with enough force as they do take a bit of welly to get them fully clipped in.


Sent from my iPhone using Tapatalk

 

[lisavx]

I got door cards from DB car trims in Blackpool and bought the clips and bungs from JK. They were tough to get on the door card and went in with a definite clip. They've been on for a while and not budged so def check your sizes and make sure they haven't sent beetle ones by mistake.

Fitting the plastic sheeting in such a way to keep them water tight was a whole other story that very nearly broke me haha [emoji31][emoji23]

Sent from my SM-G955F using Tapatalk

 

[Webbaldo]

Stainless cup washers and screws, they don't look that bad

Easy to remove without worrying about snapping clips or scratching paint either