Indicator/full beam switch

[Martinb]

Hi all,
Can anyone point me in the right director as to how I can sort out the full beam switch. Indicators work perfectly fine, but when I need to engage the full beam, nothing happens. The switch does not go into the position it should to engage the full beam. Does this mean I need a complete new indicator switch? Any suggestions as to what I should do next?

Thanks martin

 

[Bobster]

What's the bus? Is it a us import ? The switch doesn't go into a position as such but toggles the setting if that makes sense.

If it's not working it could be the relay ?

 

[Martinb]

The bus was imported from Thailand, RHD, If that helps?

 

[Bobster]

Does the indicator arm still 'pull back' as if you were flashing the lights ?

 

[Martinb]

Yes it does, but the lights don't flash

 

[Bobster]

In that case it could be either the relay or the wire connection at the indicator stalk. I would check the wire from stalk to relay (at relay end) to check that there's a current when you flash to narrow it down.

Hopefully that makes sense.