Outrigger Surgery

Early Bay Forum

Help Support Early Bay Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

james_stan

Well-known member
Joined
Jul 12, 2007
Messages
543
Reaction score
25
Location
North Beds
Hi All

Need to renew my rear offside out rigger and jackpoint plus repair inner sill
for MOT. Any tips on how best to cut off teh old bits or is a case of hack off with grinder,
cutting discs hammer and chisel...

Cheers

JS
 
james_stan said:
Hi All

Need to renew my rear offside out rigger and jackpoint plus repair inner sill
for MOT. Any tips on how best to cut off teh old bits or is a case of hack off with grinder,
cutting discs hammer and chisel...

Cheers

JS

Yep! get rid of ALL the rust, if you over plate it will only rust out the new panels. That old phrase, do it once, do it right is very true with rust repair.
 
Agreed however getting the old off is proving a PITA. I cut a section out and tried chiselling but the spot welds are holding fast. Thinking I will cut off with a 1mm disc as close as poss
to the flanges and then grind back. And there's me thinking this would be a stroll in the park.
:roll:

JS
 

Latest posts

Top