Repro gas burners

[Bobster]

Just wondering if anyone is running these on a lowered bus?

I bought some a good while ago but still haven't fitted them, I'm looking to lower the bus next month and put these on but have read that a few people have had problems with the ET so just wondering if anyone had any experience on here and if so were there any problems !

 

[neilswheels]

I had these, really tight on the back but a 195 will fit assuming your bus is orig, not had rear arches. 185's would be a safe bet. Didn't get the fronts on, decided I didn't like them so sold them

 

[AxlFoley]

I have MWS ones on my bus, I have clearence issues on the rear, my bus is dropped 4" I have folded the lip in so i can get the tyre on.

I did have clearence issues on the front, but again I have folded the lip. How low is your van ?

 

[Bobster]

It's yet to be dropped bug I'm holding out for some Thause spindles so will be 3.5 at the front. I was thinking about horseshoes for the rear but small having second thoughts following the thread on here.

 

[AxlFoley]

If you are looking for a fixed rear drop, I would highly recommend the red9design lowered spring plates, I have them and they work a treat.


Sent from my iPhone using Tapatalk

 

[sparkywig]

If you are looking for a fixed rear drop, I would highly recommend the red9design lowered spring plates, I have them and they work a treat.


Sent from my iPhone using Tapatalk

I'll have some 4" Red9 spring plates available in a couple of weeks.


Sent from my iPad using Tapatalk