Hi guys/girls
I have fitted a temp gauge and have as far as I know wired it correctly as per the instructions but when I turn the ignition on the gauge shoots up to maximum and stays there!?!?!
I have checked the voltage on the three terminals and have power to the positive and a good clean earth on the negative, the wire from the sender is showing continuity to the body.
Any ideas?
I have fitted a temp gauge and have as far as I know wired it correctly as per the instructions but when I turn the ignition on the gauge shoots up to maximum and stays there!?!?!
I have checked the voltage on the three terminals and have power to the positive and a good clean earth on the negative, the wire from the sender is showing continuity to the body.
Any ideas?