No, I haven't Poptop to run in a race against dummies as that would be silly
Yesterday, took the hinges which connect the poptop to the van drilled
(tried myself, but being stainless really struggled!) at work and they did
a grand job (industrial press drill is an essential peice of kit I thnk!)
Here is a few snaps of the poptop on, testing that all lines up etc. See what
ya think:
And here's a view from the inside (not exciting, but hey :shock: ):
The gap on the drivers side is a bit higher than I would of liked, but I
would think over the next few years, the metal will start to give and then
it should sit at a good height.
Off to Leeds shopping now so hope to do some more next week end!
Cheers
Yesterday, took the hinges which connect the poptop to the van drilled
(tried myself, but being stainless really struggled!) at work and they did
a grand job (industrial press drill is an essential peice of kit I thnk!)
Here is a few snaps of the poptop on, testing that all lines up etc. See what
ya think:
And here's a view from the inside (not exciting, but hey :shock: ):
The gap on the drivers side is a bit higher than I would of liked, but I
would think over the next few years, the metal will start to give and then
it should sit at a good height.
Off to Leeds shopping now so hope to do some more next week end!
Cheers