Afternoon,
I am using the crimbo limbo to make some headway Installing a new engine.
I am bolting all of the tinware etc to make sure it fits on a bench before I start fitting it in an engine bay..
I purchased as a kit a pair of Weber 40's with a CB linkage and manifolds. The lower part of the CB linkage does not line up to the manifold holes. The carbs line up just fine.
Is it normal to have to drill new holes for a CB linkage? I was expecting the "kit" to fit.
I am using the crimbo limbo to make some headway Installing a new engine.
I am bolting all of the tinware etc to make sure it fits on a bench before I start fitting it in an engine bay..
I purchased as a kit a pair of Weber 40's with a CB linkage and manifolds. The lower part of the CB linkage does not line up to the manifold holes. The carbs line up just fine.
Is it normal to have to drill new holes for a CB linkage? I was expecting the "kit" to fit.