Hey everyone. This is my 1968 panel. Bought it 2 years ago. It was in a fairly poor state. Over these 2 years it has had lots of welding done and a respray. Had a lot of issue with the clutch, only to fin out I had a faulty pressure plate and trust bearing.
More pics to come.
My plans are to lower it and drive it as much as possible To lower it I'm going to convert to king and linkpin, already have the beam and dropped spindles. Would you suggest I narrow the beam or keep it stock, since it's already narrower than a ball joint beam?
More pics to come.
My plans are to lower it and drive it as much as possible To lower it I'm going to convert to king and linkpin, already have the beam and dropped spindles. Would you suggest I narrow the beam or keep it stock, since it's already narrower than a ball joint beam?