1967 Neptune Blue Deluxe

[andrewblackwell]

It just sparked my imagination.
I like how you have offset the arc at the stereo ends on your plate, rather than just squared off.

 

[sparkywig]

Just a couple of little jobs completed, but these took all day.....
First of all, steering column top insulating ring replaced.





Seat belt relocation brackets fitted.



12V socket installed.



And the door membranes done, with the extra pieces that go inside the inner door frame holes.

 

[ozziedog]

Just a couple of little jobs completed, but these took all day.....
First of all, steering column top insulating ring replaced.

View attachment 9529

View attachment 9530

Seat belt relocation brackets fitted.

View attachment 9532

12V socket installed.

View attachment 9533

And the door membranes done, with the extra pieces that go inside the inner door frame holes.

View attachment 9534

View attachment 9535

And that’s a great one to get done before winter hits us..

Ozziedog,,,,,,,,,need to check mine toooo

 

[Wannabay]

Where did you get the underdash 12V/USB socket from Sparky?

 

[Albie5]

Tidy work !

 

[sparkywig]

Where did you get the underdash 12V/USB socket from Sparky?

I bought them from here

 

[sparkywig]

Diesel heater install.
Cut the perforated panel away from under the n/s seat, made a template for the holes required through the floor and drilled them out.



Inlet and exhaust installed and fuel line attached.





Fuel pump



Wiring connected and test run.



The outlet nozzle rotates, and I'll eventually fit a removable cover.
Just waiting on a bespoke diesel tank for the engine bay.



To get the heater under the seat base it can't be any wider or taller than 120mm.




Anybody need a 5kW diesel heater? It was sent by mistake and they won't accept returns.
Box only opened to measure heater body.

 

[sparkywig]

I also ran some speaker cables from the dash to the Westy bed base, but decided on a twin voice coil speaker for the original speaker position.





Unfortunately this meant the rev counter pod and wiring were in the way, so they had to be relocated. Had to drill two holes in the dash top that I wasn't too happy about, but never mind.
Speaker in and working. I added some foam seal around the edge of the speaker to wedge it under the dash edge trim and the bottom is held by two machine screws.
Quite impressed with the sound actually.