Been cleaning the engine as it was out (well in fact it has not been in van since we purchased it over two years ago!) and I had to drill out the Fuel Pump Flange which had snapped off inside ! ( I tried tap it then insert a bolt first but no joy).
So decided to clean - and I noticed that one of the push rod tubes appears to be bent!
What do I do? Is it a case of stripping the engine down further or are there any other options?
So decided to clean - and I noticed that one of the push rod tubes appears to be bent!
What do I do? Is it a case of stripping the engine down further or are there any other options?